Starting The Generator (Electric Start) - Firman P08004 Owner's Manual

4. Turn the
5. Flip the
6. Flip the

Starting the Generator (Electric Start)

Electric Start and Remote Start Operations
English
9. Do not over-choke. As soon as engine starts
move the choke lever to the
fuel valve to the "ON" (l)position.
10. Allow generator to run at no load for few
initial start-up to permit
engine switch to the "RUN(l)" position.
When starting engine, pull cord slowly until resistance is felt and
then pull rapidly to avoid kickback.
battery switch to the "ON"(l) position.
Keep choke lever in "START" position for only 1 pull of the recoil
starter. After first pull, move choke lever to the "RUN" position for
up to the next 3 pulls of the recoil starter. Too much choke leads to
sparkplug fouling/engine flooding due to the lack of incoming air.
This will cause the engine not to start.
"RUN" position.
minutes upon each
engine and generator to stablize.
Customer Service: 1-844-FIRMAN1Page 11
and warms up,