Advertisement
PID CONSTANT SETTINGS
The following is a listing of changes in constants and
programmable features as a result of installing the PID
Software EPROM set and performing constant initialization.
for Page 2-2:
Slip Compensation – (Not available in PID)
PID Control
for Page 2-21:
10
Control Section PROM
(last 5 digits of PROM
Part No. :
LHP: NSG 6XXXXX
11
Feedback Signal Monitor
12
PID Monitor
for Page 2-22:
09
PID algorithm enabled
0A - 0F
Not Used
* FBIAS1 and FBIAS2 are based on Fmax (Cn-02).
Refer to Sheet 1 for latest change.
♦
Refer to separate Option Instruction Sheet 2Y25-0346.
I70 I6
I00.00
– I00.0
All of these changes should be noted in your TM 4231.
In addition, it may be helpful to also annotate those reference
paragraphs in Section 2 where the change in constant
definition or factory setting will have some effect.
( LHP – PID )
GPD 503 controls output frequency using
PID algorithm (see instruction sheet
2Y25-0346)
(Continued)
2.26
2-41
♦
DWG. NO. 02Y00025-0346
SHEET NO. 7 OF 10
EFF. 6/12/92
( m - df )
Advertisement
