Wake_N Signal; W_Disable_N Signal - Quectel EP06 Series Hardware Design

42 WWAN_LED_N
NOTE
"*" means under development.

3.7.1. WAKE_N Signal*

The WAKE_N signal
AT+QCFG="risignaltype","physical" command are required. When a URC is returned, a low level
pulse will be outputted. The state of WAKE_N signal is shown below.

3.7.2. W_DISABLE_N Signal*

The module provides a W_DISABLE_N signal to disable or enable the RF function (excluding GNSS).
W_DISABLE_N for RF function control is disabled by default, and AT+QCFG="airplanecontrol",1 can
be used to enable the function.
W_DISABLE_N is pulled up by default. Driving it low sets the module into airplane mode.
Table 10: RF Function Status
W_DISABLE_N Level
High Level
High Level
EP06_Series_Hardware_Design
It is an open collector and active
low signal.
OD It allows the module to provide RF
status indication via LED devices
provided by the system.
is an open collector
High
(external
pull-up)
Low
URC return
Figure 9: WAKE_N Behavior
AT Commands
AT+CFUN=1
AT+CFUN=0
EP06 Series Hardware Design
signal, but a
TBD
RF Function Status
Enabled
Disabled
LTE-A Module Series
Active low.
host pull-up resistor and
26 / 56