Advertisement
Assembly Instructions Page 1
ALL PHOTOS TAKEN FROM FRONT VIEW UNLESS OTHERWISE NOTED
Remove all contents from packaging and make sure all parts are present before attempting to assemble.
Tighten all bolt connections by hand first and then when fully assembled, go back and tighten with a wrench.
1
SIDE VIEW
center spacers located here
3
Distributed by Primal Vantage Company Inc., 2407 W. Euclid Ave., Littleton, CO 80120
Customer Service Department 1-866-972-6168
Attach Left Ladder
Jaw
and Right
1
Ladder Jaw
to Tree
Brace
using
2-M8x90mm bolts
with spacers
on
each side.
2
Slide Handle Rails
Tree Brace
Rails
Carefully tilt Handle Rail / Tree Brace / Ladder Jaw assembly
upward so that the Ladder Jaws
3
and the ends of Handle Rails
ends of Top Ladder Section
Handle Rails
NOTE: Continue to leave Handle Rails
Tree Brace
17' Single Vantage Deluxe Ladder Stand
2
onto right and left front ends of
assembly. NOTE: Do not secure Handle
with bolts at this step.
and
are held upward. Slide the top
into the downward facing ends of
. Attach using 2-M6x30mm bolts
.
Model: PVLS-316
are towards the ground
un-secured to the
©2020 (rev. 1/20)
Advertisement
