Advertisement
Installation Instructions Page 1
1
1
Position bottom of stand 4-5 feet from base of tree
NOTE: Make sure that Ladder Jaws
in their open most position.
3
As tree stand is being raised, the
person holding Installation Straps will
3
pull toward themselves to take up slack.
It will steady and ease the weight of
stand on the other two people. Continue
walking stand upward, until Tree
Contact is resting against the tree.
W A R N I N G
DO NOT climb ladder without Truss Assembly or
Installation Straps installed. Serious injury or
death may occur if stabilizer bar is not installed.
NOTE:
Distributed by Primal Vantage Company Inc., 2407 W. Euclid Ave., Littleton, CO 80120
Customer Service Department 1-866-972-6168
and
are
4
Move base of ladder toward or
away from the tree slightly in
order to make Platform as
4
Parallel to the ground as
possible.
Apply your full weight to the first
step so it settles into the ground.
Drawings are for illustration purposes only and may not depict actual product.
17' Single Vantage Deluxe Ladder Stand
2
One person will stand at the base of ladder with
2
his/her foot on the bottom rung while holding
installation straps. This will prevent tree stand from
sliding. Two people will stand at opposite ends of
tree stand, facing Platform and slowly walk tree
stand upward using rungs of ladder.
5
5
W A R N I N G
Truss Assembly and Installation Straps MUST be secured
prior climbing the Ladder Stand. Failure to comply may
result in serious injury or death.
Model: PVLS-316
Cross Installation Straps behind tree.
Attach to the top rung of the bottom
ladder section. Pull to tighten the
straps against the tree.
(See Installation Strap Instructions).
©2020 (rev. 1/20)
Advertisement
