Advertisement
Assembly Instructions Page 5
BOTTOM
13
strap passes
through these
metal loops
NOTE: When fastening the Horizontal Jaw Strap
must be inserted as follows.
14
Right Jaw (curved)
Jaw Assembly Strap fastener and then through the top of the Right Jaw
Straight Jaw (straight)
Jaw Assembly Strap fastener and then through the bottom of the Straight Jaw
15a
15a/15b: Attach Ratchet Straps
side of the Tree Brace
15
Instructions for correct weaving).
15a/15b: Attach Installation Straps
above) (See Installation Strap instructions for correct weaving).
Distributed by Primal Vantage Company Inc., 2407 W. Euclid Ave., Littleton, CO 80120
Customer Service Department 1-866-972-6168
Carefully tilt ladder stand assembly forward so that the bottom is facing
forward and the rear is facing upward. With Horizontal Jaw Assembly Strap
13
connect the two right/left ends of the Horizontal Jaw Assembly Strap
Left Ladder Jaw
Check to make sure that Vertical Jaw Assembly Strap
through the metal loops on tree brace
Platform Assembly
- Insert 1-M8x45mm bolt
through the Horizontal
45
- Insert 1-M8x45mm bolt
45
BOTTOM
15b
on either outer
(See Ratchet Strap
on either outer side of the Tree Brace
17' Single Vantage Deluxe Ladder Stand
passed through the top loop of Vertical Jaw Assembly Strap
and Right Ladder Jaw
(as shown right).
to the Jaws, the bolts
.
through the Horizontal
.
BOTTOM
just behind the ratchet straps
Model: PVLS-316
using 2-M8x45mm bolts
is passing
and the bottom of the Foot
14
From
top
bottom
Curved Jaw
BOTTOM
,
to
.
Straight
Jaw
From
(as shown
©2020 (rev. 1/20)
Advertisement
