Advertisement
Installation Instructions Page 2
6
O
Y
7
Y
CC
Y
8
BB
Distributed by Primal Vantage Company Inc., 2407 W. Euclid Ave., Littleton, CO 80120
Customer Service Department 1-866-972-6168
NOTE: The Ladder Jaws are designed to
wrap around a tree trunk when Vertical
Jaw Assembly Strap
P
Before engaging the Ladder Jaw
Mechanism:
1) Check that the Ladder stand is properly
installed on correct sized tree. If the
ladder jaws
tree trunk, the tree is too large for safe
installation.
2) Check that the installation straps
correctly wrapped around the tree base and
tightly secured
3) The Truss Mechanism is properly tensioned.
4) The ladder base is correctly and safely
secured onto level ground.
Check to make sure the Vertical Jaw
Assembly Strap
S
or snagged. Make sure the strap falls flat
and straight from the foot platform.
Carefully loop the Vertical Jaw Assembly
Strap through either the right or left metal
hooks on the Truss Bar
Lightly pull on Vertical Jaw Assembly strap
Y
to and check to make sure that both
ladder jaws close in on the tree trunk.
Loop Jaw Assembly Tree Buckle
CC
through Jaw Assembly Ratchet Strap
With the Jaw Assembly Ratchet Strap
attached, wrap the Jaw Assembly Tree
Buckle
BB
diagonal point from the Truss Bar
shown right). Feed Jaw Assembly Tree
Buckle Webbing though the spring loaded
cam buckle and firmly tighten around tree
trunk.
(See "Tree Buckle Strap Instruction")
Position Jaw Assembly Ratchet Strap
so that it faces the ladder. Feed Jaw
Assembly Vertical strap
strap
and ratchet the strap tight until the
CC
tension closes the ladder jaws.
See "Ratchet Strap Instructions").
Y
is tightened.
O P
cannot close on the
W
are
Y
is not caught, tangled
(as shown left).
S
BB
CC
CC
around tree trunk at a lower
S
(as
CC
Y
through ratchet
17' Single Vantage Deluxe Ladder Stand
.
NOTE: Ladder should arc slightly
outward even after Jaw Assembly
Strap Webbing
Model: PVLS-316
is fully tightened
©2020 (rev. 1/20)
Advertisement
