Advertisement
Truss Assembly Instructions
1
E
3
Distributed by Primal Vantage Company Inc., 2407 W. Euclid Ave., Littleton, CO 80120
Customer Service Department 1-866-972-6168
Carefully lay fully assembled Ladder
Stand front ladder side down so that the
tree attachment side is facing upward.
Attach the hooked side of Truss Cable
1
eyelet hole welded on the bottom front
of the foot platform assembly (as shown
left)
NOTE: Top hook should ALWAYS face
inward, away from the front of ladder
(as shown left).
Stand in the middle of the ladder, pull up on the Truss Cable
onto the Y-shaped end of the Truss Bar
3
is enough tension to create a slight bow in the Ladder Structure (as shown above).
NOTE: It should take minimal effort to lift the Truss Cable onto the Truss Bar, if
truss cable is not easy to lift, STOP immediately, loosen the truss adjuster and
repeat the process.
NOTE:
Drawings are for illustration purposes only and may not depict actual product.
without the tension adjuster to the
E
.
Attach the hooked side of Truss Cable
adjuster to the eyelet hole welded on the bottom rung of
2
Bottom Ladder Section
NOTE: It may be necessary to pre-tension the cable by
tightening the tension adjuster several turns clockwise
before placing it on the Truss Bar
17' Single Vantage Deluxe Ladder Stand
2
.
.
. Tighten the cable so that there
Model: PVLS-316
with the tension
and place it
©2020 (rev. 1/20)
Advertisement
