Table of Contents
Advertisement
Installation, Operation & Maintenance Manual - PS-121B / PSH-141A
Installation, Operation & Maintenance
Upper filter
(take out)
Remove the
screw ,then
take the lower
filter out.
Upper filter
(install)
Install the lower
filter by using
the screw.
Buckle
Power
cord
Power plug
PSH-141A
CARE AND MAINTENANCE
IMPORTANT:
1) Be sure to unplug the unit before cleaning or servicing.
2) Do not use gasoline, paint thinner or other chemicals to clean
3) Do not wash the unit directly under a tap or using a hose.
4) If the power cord is damaged, it should be repaired by
Fig.21
1. Air filter
-
-
-
Fig.22
-
2. Unit Cabinet
-
3. Unit storage when not in use
Power plug
-
socket
Fig.23
-
-
-
-
-
Fig.24
CARE AND MAINTENANCE
the unit.
It may cause electrical danger.
an authorized servicer.
Clean the air filter at least once every two weeks.
Removal
This unit has two filters. Take the upper filter out along the
the arrow direction (Fig.21),then take the filter down.
Remove the lower filter by loosening the screw, taking out
the filter as shown in Fig.21.
Cleaning
Wash the air filter by immersing it gently in warm water
(about 104 F/40 C) with a neutral detergent. Rinse the filter
O
O
and dry it in a shady place.
Installation
Insert the upper air filter after cleaning, and reinstall the lower
filter by using the screw (see Fig.22).
Use a lint-free damp cloth with neutral detergent to clean the
cabinet. Finished by drying with a clean, dry cloth.
Remove the rubber plug at the back of the unit and attach a
hose to the drain outlet . Place the open end of the hose
directly over the drain area in your basement floor
(See Fig.18 & 19).
Remove the plug from the bottom drain outlet, all the water in
the bottom tray will drain out (See Fig.21).
Keep the appliance running in FAN mode for half a day in
a warm room to dry the appliance inside and prevent mold
from forming.
Stop the appliance and unplug it, wrap the cord and bundle it
with the buckle and plug the power plug into the socket on the
back of the unit. (Fig.23). Remove the batteries from the
remote controller.
Clean the air filter and reinstall it.
Unscrew the exhaust hose from the unit and pull out when
uninstallating (Fig.24).
14
14
Heat Controller
Advertisement
Table of Contents
