Using The Handscanner; Charging The Handscanner; Removing The Handscanner Battery - HID Technology Solutions 1062 User Manual

www.tsl.com

USING THE HANDSCANNER

CHARGING THE HANDSCANNER

The Handscanner is charged by docking it in the cradle. Plug the power supply provided with the cradle in to
the power in socket on the back of the cradle. The charge time will depend on how discharged the Handscanner
battery is. Typically a fully discharged battery will take 3-4 hours to fully charge. The LEDs on the top of the
Handscanner indicate the charge status; Red for charge in progress, Green for charge complete. Both LEDs on
simultaneously indicates a fault condition. This will happen if the battery is outside the recommended charging
temperature (0°C to 45°C), or if the battery has a fault.
The cradle is also capable of charging a spare battery at the same time as a Handscanner. The spare battery
drops into the holder at the back of the cradle. The charge time in the cradle is the same as the Handscanner.
Charge status is indicated by the LEDs on the cradle. Red indicates charge in progress, Green charge
complete and Red and Green for fault (or battery not present). Note that the charge status of the spare battery is
independent of the Handscanner.

REMOVING THE HANDSCANNER BATTERY

1) Press in the yellow button 2) Slide the battery cover down and lift it off.
The battery can then be lifted out and replaced. Refit the cover by sliding it back up until the button clicks in place.
7
Copyright © 2021 Technology Solutions (UK) Ltd 1062 Handscanner User Guide V1.41