Chapter 2: System Installation
Attach product discharge and air supply hoses to the proper barbed fittings on the pump.
Refer to Figures 1 and 2 below for fitting configurations.
If pump configuration was not assembled as a complete system,
please use the following steps:
Attach air supply hose to Geotech pneumatic controller air supply fitting.
Ensure all hoses are installed properly and securely to the fittings.
Attach the safety cable to the support loop using proper crimps or cable clamps.
The Reclaimer can now be lowered into the recovery well. For optimum efficiency, the
Reclaimer must be positioned in the well with the intake adequately submerged.
Air
Figure 1
1.66" Reclaimer Bottom Fill
Discharge
Fluid
Intake
4
Figure 2
1.66" Reclaimer Top Fill
Discharge
Air