SECTION 10: W
IRING
10.2.2 Satellite Heater Configuration
Satellite heater configuration is set by positioning of
jumpers on pin block J10 located on the control board
inside the heater compartment, See Page 47 , Figure
27. Jumper position on J10, shown on Page 47 ,
Figure 27 will configure heater as a satellite heater.
(The jumper position for satellite is the same as the
jumper position of a central heater using a zone
sensor). Jumper on J9 may be left alone.
FIGURE 27: Satellite Heater Jumper Setting
47 of 80