Roberts Gorden Vantage HEM-80 Installation, Operation & Service Manual page 25

Step 6.4 Coupling and Tube Assembly
A
Close coupling and slide
opposite end into tab.
Position tab underneath
guide rail.
C
Insert tubes into coupling
until end of each tube rests
against internal pins.
Step 6.4.1 Coupling and Tube Assembly (Continued)
Tighten slide bar as shown below.
• Repeat Step 6.4 A - D until all tubes are assembled. See Page 22, Section 6.4.2.
B
Insert wide end of slide bar/coupling lock into
guide rail on opposite end of tabs. Slide the slide
bar/coupling lock up the guide rail until snug
(approximately 3" (8 cm) to 4" (10 cm)).
D
Strike slide bar/coupling lock with mallet or hammer
until tight.
Description Part Number
Coupling
Slide Bar/Coupling Lock
Tube 91409XXX
SECTION 6: H I
EATER NSTALLATION
01329600
01329700
21 of 80