Roberts Gorden Vantage HEM-80 Installation, Operation & Service Manual page 15

FIGURE 14: Major Component Descriptions - High Efficiency Reflector
Burner with Tube Gasket
Burner Tube
Supplied in 10
'
(3 m) lengths. Burner
tube is always the first tube
after the burner.
Tube and Reflector Hanger
with Clamp Package-EF
Position this hanger no more
than 4" (10 cm) away from
the burner.
Tube and Reflector Hanger-EF
Suspend system from these hangers.
Reflector Support Strap &
Wire Form-EF
Flex Gas Line with
Shut Off Cock
Must be installed with the
flame observation
window facing down.
Combustion Air
Weather Vent
Attach at flue end
and air inlet
where required.
High Efficiency Reflector
(Aluminum)
Alternate overlap as shown on
overview and on Page 19,
Figure 18. Minimum overlap is
6" (16 cm).
Tube
Heat treated aluminized
tube supplied in 10' (3 m)
lengths.
Install turbulator
as specified in the
"Turbulator Installation" chart.
See Page 22, Step 6.5.
Turbulator is not required on the
HEM-200.
SECTION 5: M C
AJOR
Coupling Assembly
with Lock
Reflector End Cap-EF
Punch out center
section to
accommodate tube.
Vent Adapter
Turbulator
OMPONENTS
11 of 80