Notes On The Setup Menu; Exiting The Setup Menu - Abs Enclosure; Setup Menu Chart - Salter Brecknell S750 Series Operation/Setup Manual

F1 F2
Grads Span Gn.
0d
25 50 75 100 150 200
500 1000 1500 2000 2500 3000 4000 5000 6000 8000 10000 12000 20000 30000 40000 50000
F9 F10
Dsp. Div. Dec. Pt.
1 2 5
0 0.0 0.00 0.000 0.0000 00
F16
Zero Calib.
Press ZERO
key to begin

3.2.4 NOTES ON THE SETUP MENU

1. There is an F21 sub-menu present that is for FACTORY USE ONLY!
2. Detailed descriptions of the setup menu parameters can be found in Chapter 4 of this
manual.
3. The User ("A") menu sub-menus appear when scrolling left or right from the "F" menu.
3.2.5 EXITING THE SETUP MENU – ABS ENCLOSURE
1. Power off the indicator by unplugging the power source.
2. On the back cover, move the Setup/Calibration Switch back to its original position.
3. Power on the indicator by plugging in the power source. The display will go through a digit check, then
settle into Normal Operating mode. All front panel keys will now return to their normal mode of operation.
F3
F4
Zero Band
Zero Range
0.5d 1d 3d 5d
100% 1.9%
F12
F11
CU Enable
CU Mult.
Press ZERO
key to begin
F17 F18
Span Calib. Cal. View
Press ZERO Press ZERO
key to begin key to begin
Figure 3-2: Setup Menu Chart
Page C-1
F5 F6
Mot. Band Dig. Filter
1d 3d 5d 10d
Auto
1 2 4 8
F13
PC Enable
0 1
0 1
F19 F20
Key-in Span
Key-in Zero
Press ZERO
Press ZERO
key to begin key to begin
F7 F8
Ovld. Limit Calib. Unit
0d 2% 1d 9d
12 16 32 64
lb kg
F14
lb/kg Enable
0 1