Table of Contents
Advertisement
3.2.6 EXITING THE SETUP MENU – STAINLESS STEEL ENCLOSURE
1. Power off the indicator.
2. Move the slide switch on the rear cover back to the left.
3. Power on the indicator. The display will go through a digit check, then settle into Normal
Operating mode. All front panel keys will now return to their normal mode of operation.
Note: If your indicator is an older model and does not have the slide switch on the rear
cover, follow these instructions instead:
TI-S750S
1. Remove the rear cover and locate jumper JP2.
2. Position the shunt block as shown at right.
Note: On certain units, the shunt block position will be exactly the opposite.
3. Power on the indicator. The display will go through a digit check, then settle into Normal Operating
mode. All front panel keys will now return to their normal mode of operation.
3.3
USER ("A") MENU
3.3.1 ENTERING THE USER MENU
1. Enter the Setup ("F") menu by following the directions in Section 3.2.1 or 3.2.2.
2. Use the right or left directional keys shown in Figure 3-3 to move right or left in the
Setup ("F") menu until the indicator shows " A 1".
3.3.2 NAVIGATING IN THE USER MENU
Use the directional keys shown in Figure 3-3 to move around in the User Menu Chart shown
in Figure 3-4 on the following page.
1. To move to a new "A" heading, use the TARE (left) or PRINT (right) key to move right or left in the
User Menu Chart.
2. To move to the selection level, press the ZERO (down) key once. The current saved selection is
shown.
3. To view the available selections for the current "A" heading, use the TARE (left) or PRINT (right) key
to move through the selection field.
4. To save a new selection, press the NET/GROSS (Set) key .To exit without saving, press the UNITS
(up) key to return to the current "A" heading.
5. Repeat Steps 2 through 5 until the User Menu is programmed.
JP2
Page C-1
Advertisement
Table of Contents
