Notes On The Setup Menu; Exiting The Setup Menu; Setup Menu Key Assignments; Setup Menu Chart - Salter Brecknell 400 Series Setup & Operation Manual

4. To save a new selection, press the NET/GROSS (Set) key .To exit without
saving, press the 1 (up) key to return to the current "F" heading.
5. Repeat Steps 1 through 4 until the Setup Menu is programmed.
F1 F2 F3
Grads Span Gn. Zero Band
0d 0.5d 1d
25 50 75 100 150 200
500 1000 1500 2000 2500 3000
F9 F10
Dsp. Div. Dec. Pt.
1 2 5
0 0.0 0.00 0.000 0.0000 00

3.2.3 NOTES ON THE SETUP MENU

1. There is an F21 sub-menu present that is for FACTORY USE ONLY!
2. Detailed descriptions of the setup menu parameters can be found in Chapter 4 of this
manual.

3.2.4 EXITING THE SETUP MENU

1. Power off the indicator.
2. Move the slide switch on the rear cover back to the left.
3. Power on the indicator. The display will go through a digit check, then settle into
Normal Operating mode. All front panel keys will now return to their normal mode of
operation.
SETUP MENU MODE KEY FUNCTIONS
1 2
GROSS
SET
Figure 3-1: Setup Menu Key Assignments
F4 F5
Zero Range Mot. Band
3d 5d
1d 3d 5d 10d
100% 1.9%
4000 5000 6000 8000
F16 F17
Zero Calib. Span Calib.
Press # 2 Press # 2
key to begin key to begin
Figure 3-2: Setup Menu Chart
Page 3 - 2
NET
4
5
F6
Dig. Filter
1 2 4 8 16 32
10000 12000 15000 20000
F18 F19
Cal. View Key-in Zero
Press # 2 Press # 2
key to begin key to begin
F7 F8
Ovld. Limit Calib. Unit
0d 2% 1d 9d
lb kg
30000 40000 50000
F20
Key-in Span
Press # 2
key to begin