Table of Contents
Advertisement
3.2.3 NAVIGATING IN THE SETUP MENU
Use the directional keys shown in Figure 3-1 to move around in the Setup Menu Chart
shown in Figure 3-2 on the following page.
1.
To move to a new "F" heading, use the TARE (left) or PRINT (right) key to move right
or left in the Setup Menu Chart.
2.
To move to the selection level, press the ZERO (down) key once. The current saved
selection is shown.
3.
To view the available selections for the current "F" heading, use the TARE (left) or
PRINT (right) key to move through the selection field.
4.
To save a new selection, press the NET/GROSS (Set) key .To exit without saving,
press the UNITS (up) key to return to the current "F" heading.
5.
Repeat Steps 1 through 4 until the Setup Menu is programmed.
Figure 3-1: Setup Menu Key Assignments
Page C-1
SET
Continued =>
Advertisement
Table of Contents
