Maintenance; Protecting The Environment - Black & Decker NSVA315J Manual

Fit the floor head (6) to the opening on the dust chamber
u
(4) at the front of the Dustbuster
connector (5) as shown in figure C.
Charging the battery (Fig. D, E)
Place the charger (7) into the charging port (7a) at the rear
u
of the unit and plug into the electrical outlet.
Switch the electrical outlet on.
u
Use
Before first use, the battery must be charged for at least
u
10 hours.
Switching on and off (Fig. F
To switch the appliance on, push the on/off switch (2) to
u
the forward position.
To switch the appliance off, return the on/off switch (2) to
u
the back position.
Warning! Never pick up wet applications with these units.
Optimising the suction force
In order to keep the suction force optimised, the filters must be
cleared regularly during use.
Emptying and cleaning the product.
Removing the dust bowl and filters (Fig. G, H, I, J).
Press the dust chamber release button (3)and remove the
u
dust chamber (4) from the motor unit as shown in figure G.
While holding the dust chamber (4) over a suitable
u
receptacle, pull out the filter (10).
Shake the dust chamber (4) over a suitable receptacle to
u
empty the contents as shown in figure I.
To replace the dust bowl, push it back onto the motor unit
u
until it locks firmly into position.
Warning! Never use the appliance without the filters.
Optimum dust collection will only be achieved with clean
filters.
The dust bowls and filters can be washed in warm soapy
u
water.
Make sure that the filters and the dust bowl are dry before
u
re-fitting.
Replacing the filters
The filters should be replaced every 6 to 9 months and
whenever worn or damaged.
Replacement filters are available from your BLACK+DECKER
dealer.
unit via the floor head
®
)
Storage (Fig. K)
Your BLACK+DECKER NVSA315J can be hung from a wall
fitting (not supplied) by using the hole in the handle (11) as
shown in figure K.

Maintenance

Your BLACK+DECKER corded/cordless appliance/tool has
been designed to operate over a long period of time with a
minimum of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Warning! Before performing any maintenance on corded/
cordless power tools:
Switch off and unplug the appliance/tool.
u
Or switch off and remove the battery from the appliance/
u
tool if the appliance/tool has a separate battery pack.
Or run the battery down completely if it is integral and then
u
switch off.
Unplug the charger before cleaning it. Your charger does
u
not require any maintenance apart from regular cleaning.
Regularly clean the ventilation slots in your appliance/tool/
u
charger using a soft brush or dry cloth.
Regularly clean the motor housing using a damp cloth. Do
u
not use any abrasive or solvent-based cleaner.

Protecting the environment

Z
Separate collection. Products and batteries
marked with this symbol must not be disposed of
with normal household waste.
Should you find one day that your Black & Decker product
needs replacement, or if it is of no further use to you, do not
dispose of it with household waste. Make this product
available for separate collection.
z
Separate collection of used products and packag-
ing allows materials to be recycled and used again.
Re-use of recycled materials helps prevent enviro
mental pollution and reduces the demand for raw
materials.
Local regulations may provide for separate collection of elec-
trical products from the household, at municipal waste sites or
by the retailer when you purchase a new product.
Black & Decker provides a facility for the collection and
recycling of Black & Decker products once they have reached
the end of their working life. To take advantage of this service
please return your product to any authorised repair agent who
will collect them on our behalf.
ENGLISH
7