Inspection And Repairs; Electrical Safety - Black & Decker NSVA315J Manual

ENGLISH

Inspection and repairs

Before use, check the appliance for dam-
aged or defective parts.
Check for breakage of parts, damage to
switches and any other conditions that
may affect its operation.
Do not use the appliance if any part is
u
damaged or defective.
Have any damaged or defective parts
u
repaired or replaced by an authorized
repair agent.
Regularly check the charger lead for
u
damage. Replace the charger if the
lead is damaged or defective.
Never attempt to remove or replace
u
any parts other than those specified in
this manual.
Chargers
Your charger has been designed for a
specific voltage. Always check that the
mains voltage corresponds to the voltage
on the rating plate.
Warning! Never attempt to replace the
charger unit with a regular mains plug.
Use your BLACK+DECKER charger
u
only to charge the battery in the
appliance with which it was supplied.
Other batteries could burst, causing
personal injury and damage.
Never attempt to charge non-
u
rechargeable batteries.
If the supply cord is damaged, it must
u
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Do not expose the charger to water.
u
Do not open the charger.
u
6
Do not probe the charger.
u
The appliance/battery must be
u
placed in a well ventilated area when
charging.

Electrical safety

Symbols on the charger
Read all of this manual carefully before using the
# appliance.
This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
$
corresponds to the voltage on the rating plate.
The charger is intended for indoor use only.
Labels on appliance
The following symbols appear on this appliance along with the
+
date code.
Read all of this manual carefully before
using the appliance
Only use with charger S003AQ-15
S003AQ-15
Features
This tool includes some or all of the following features.
1. Extension pole release button
2. On/Off switch
3. Dust chamber release button
4. Dust chamber
5. Floor head connector
6. Floor head
7. Charger
8. Extension pole
9. Handle
Assembly (Fig. A, B, C)
Push the handle (9) firmly into the extension pole (8) as
u
shown in figure A.
Note: This process only needs to be performed once, as you
will be unable to remove the handle from the extension pole
once it is locked in place.
Push the extension pole (8) into the opening on the
u
Dustbuster until it clicks into place as shown in figure B.
®
To release the extension pole from the Dustbuster
the extension pole release button (1).
press
®