Table of Contents
Advertisement
The numbers represent the channel, while the letters represent the group.
A.
When using a single flash, set it to the same group and channel as the master.
B. When using multiple flash units, select the same group and channel for all units being used in a
particular light position. For example, if you are using three VS-510N units, you might want to set two
as a main light on 1A, and set the third as a fill light on 1B.
5.
If desired, adjust the flash coverage angle by pressing the Zoom button repeatedly.
6.
Make sure that the red light on the front of the flash is flashing. This indicates that the unit is ready to fire
in wireless TTL slave mode.
Using Your VS-510N as a Wireless Manual Flash
For even greater creative control, you can set the output levels of your remote flash units manually.
Using the optical slave feature, the VS-510N can be set to fire whenever it detects a signal from the master
flash. This works optically—when the VS-510N "sees" another flash firing, it will instantaneously fire along
with it.
Using Your VS-510N as a Wireless Manual Flash
|
33
Advertisement
Table of Contents
