Table of Contents
Advertisement
fire before the camera's shutter opens. In order to ensure that the VS-510N fires at the correct time, there are
three different slave modes available: modes 0, 1, and 2. To select the correct slave mode, follow these steps:
1.
Make sure the slave mode switch is in the "S" position.
2.
Press the Mode button repeatedly to cycle through the slave mode options on the LCD.
A.
In mode 0, the flash will fire on the first (or only) burst of light. Use this mode when the master flash
is set to manual.
B. In modes 1 and 2, the slave will ignore either one or two pre-flashes, respectively. Use these modes
when the master flash is set to TTL or automatic modes. Whether the master emits one pre-flash or
two will depend on the camera and settings—always take a test exposure to ensure that the slave
is set correctly.
Using Your VS-510N as a Wireless Manual Flash
|
35
Advertisement
Table of Contents
