Table of Contents
Advertisement
Using Your VS-570C as a Wireless Manual Flash
For even greater creative control, you can set the output levels of your remote flash units manually.
Using the optical slave feature, the VS-570C can be set to fire whenever it detects a signal from the master
flash. This works optically—when the VS-570C "sees" another flash firing, it will instantaneously fire along
with it.
Setting the remote flash units manually: To set a VS-570C flash unit to function as a slave with the output
level selected manually, follow these steps:
1.
In Manual mode, use the up and down buttons to select the power output (1 through 1/64).
1.
Press the Mode button once to enter Slave mode.
2.
Set the slave mode as desired (See Setting the slave mode on page 51).
3.
If desired, adjust the flash coverage angle by pressing the Zoom button repeatedly.
4.
Make sure that the master flash on your camera is on and set to the appropriate mode. If you don't want
the master flash to illuminate a subject in front of the camera, tilt the head upward.
|
50
Using Your VS-570C as a Wireless Manual Flash
Advertisement
Table of Contents
