Crimping Heads - Panduit CT-600-A Operating Instructions Manual

© Panduit Corp. 2013
Make sure the air supply is "OFF"
before installing the crimping heads
and move the "SAFETY LOCK" lever
to the "DOWN" position.

CRIMPING HEADS

To install the crimping heads, turn the air supply "OFF", move the "SAFETY LOCK" lever to the
"DOWN" position and retract the two Lock Pins located at the head of the tool. With the jaws wide open
(rollers touching), slide the crimping head into the tool body and align the mounting holes in the tool
frame. Insert the Lock Pins and snap securely into place. Wipe any excess oil from the crimping dies
before using.
OPERATING INSTRUCTIONS
CAUTION
Page: 2 of 12
AVAILABLE CRIMPING HEADS
(Sold Separately)
Panduit Terminal
Part No.
CT-500CH Insulated
CT-520CH Insulated
CT-550CH Insulated
CT-570CH Non-Insulated
CT-600-A
Wire
Type Range
22-14
26-14
22-10
22-10