Advertisement
Important: Remove Metal Roof Hangers
56.
Before fully fastening Metal Roof Panels down, remove the Metal
Roof Hangers and insert Foam Enclosures between Metal Roof Panels
and Battens at the bottom of the roof. Enclosures will prevent moisture
and unwanted bugs, etc from entering your shed through here.
57.
Using 12 - 2" Metal Screws and 1/4" Nut Driver, secure Metal Roof
Panels down to lower 2 rows of Battens. Leave the top row unsecured for
now to secure Ridge Cap to later in Step 60. Tighten screws in middle row
that were partially attached in Step 55. Do not Overtighten!
58.
Repeat Steps 52 - 57 to complete opposite side of roof.
Toll Free 1-888-658-1658
www.outdoorlivingtoday.com
Page 27
Parts (Step 56)
Foam Enclosures
(Several Pcs)
Screw into center of Battens.
Hardware (Step 57)
2" - Metal Roof Screws
sales@outdoorlivingtoday.com
x 12
Advertisement
