Advertisement
13.
Lay out all the wall panels and become familiar with their
location. On a Standard Kit, there is 1 Window Wall Panel, 6 Solid
Wall Panels and 1 Narrow Wall Panel. Make sure to position pan-
els right side side up so water is directed away from and not into
shed. Compare siding with Window Wall Panel to determine proper
wall orientation.
14.
Starting at Rear Corner, position a Solid
Wall Panel on top of plywood floor. The Wall
Panel bottom framing will sit flush with floor
framing.
15.
The side wall panels will sit flush at the
corner of the floor, with the front and rear
wall panels sandwiched between them.
Note: Siding will overhang the floor by
approximately 1/2".
Toll Free 1-888-658-1658
Important: Make sure all walls are aligned
in their upright position. If not, water may
leak into your shed. Unsure if panel is
facing up or down?
window wall panel to match alignment.
Side Wall Panel
Outside 2x3 framing of wall panel
is flush with outside of floor frame
when properly aligned.
www.outdoorlivingtoday.com
Page 11
Parts (Steps 13 - 21)
Solid Wall Panels
(45 1/2" x 75") x 5
Window Wall Panel
(45 1/2" x 75") x 1
Hardware (Steps 13 - 21)
S1 - 2 1/2" Screws
x 18 total
check siding on
sales@outdoorlivingtoday.com
Advertisement
