Advertisement
0910-7215-04_V1.qxd:_
INSTALLATION
1. To activate the alarm, install the alarm on the mounting bracket (Figure 6) and
rotate the alarm clockwise (as indicated on the alarm cover) until the alarm ratchets
into place (the ratcheting function allows for aesthetic alignment). NOTE: The
alarm will mount to the bracket in four (4) positions (every 90 degrees).
The alarm is now activated!
2. After installation/activation, test your alarm by depressing and holding down the
test button for a minimum of 5 seconds (or until the alarm sounds). This should
sound the alarm. CAUTION: Due to the loudness (85 decibels) of the alarm,
always stand an arms length away from the unit when testing.
TAMPER RESIST FEATURE
Smoke Alarm Tamper Resist Feature
To make the smoke alarm tamper-resistant, a tamper resist feature has been provided.
To activate this feature you must break out the 4 tamper-resist blocks on the mount-
ing plate (see figure 7A). Use a small screw driver.
The tamper resist feature will deter children and others from removing the alarm from
the bracket. NOTE: To remove the alarm when the tamper resist tab is engaged, press
down on the tamper resist tab and rotate the alarm anti-clockwise in the direction
indicated by the arrows on the cover of the alarm (see Figure 7B).
8
2011.12.1
BREAK
OUT
FIGURE 7A
FIGURE 7B
10:27 AM
Advertisement
