Plasmacluster Mode; Full Power Mode; Other Functions; Setting The Swing Function - Bosch Climate 6100i Operation Manual

Operation
If the outside temperature is very low, the heating capacity of the air
conditioning system may not be sufficient. We recommend connecting
additional heat sources.
Set fan speed
▶ Press the Fan button to set the desired fan speed.
1 2
[1] Auto
[2] Quiet
[3] Soft
[4] Low
[5] High
Switching the appliance off
▶ Press the Stop button.
The green operation lamp K turns off.
3.8

Plasmacluster mode

Plasmacluster ions released into the room are effective against airborne
contaminants, such as mold, viruses, and allergens.
▶ During operation, press button.
The remote control displays
The blue plasmacluster lamp on the unit lights up.
To cancel:
▶ Press button again.
The blue plasmacluster lamp on the unit turns off.
NOTICE
▶ Use of the plasmacluster mode will be memorized, and it will be
activated the next time you turn on the air conditioner.
▶ To perform the plasmacluster mode with fan only mode, press the
plasmacluster button while the unit is not operating. The operation
mode symbol at the top left on the remote control will disappear and
the fan speed can not be set to auto.
3.9

Full power mode

In this operation mode, the air conditioner works at the maximum power
to rapidly heat or cool the room.
▶ During operation, press the
The remote control displays
To cancel full power mode:
▶ Press the button again.
The unit returns to its original settings.
Full power mode will automatically cancel after one hour.
You can not set the temperature or fan speed during full power mode.
6
3 4 5
0010030443-001
.
button.
and the temperature disappears.
3.10

Other functions

3.10.1 Setting the swing function

NOTICE
If the louvres remain at the lowest position during cooling mode for an
extended period, condensate may form. Adjusting the louvres by hand
may cause faults.
▶ Only use the remote control to adjust the louvres.
Vertical Swing mode
▶ Press the button to set the desired airflow direction.
The adjustment possibility of the combustion air supply depends on the
operation mode selected:
• In cooling mode, the combustion air supply can also be directed to
the ceiling.
• In heating mode on the other hand, the combustion air supply can be
selected for the underfloor
• Automatic mode does not allow any flow settings to the ceiling or
underfloor.
The setting AUTO has the following behaviour:
• Cooling mode: the airflow direction will be set obliquely downward,
and then shifted to horizontal or obliquely upward to direct cool air at
the ceiling.
• Heating mode: the airflow direction will be set obliquely upward
when the extract air temperature is low, then shifts to obliquely
downward when the extract air becomes hot.
Horizontal Swing mode
▶ Press the button to set the desired airflow direction.

3.10.2 Spot airflow mode

The airflow louver can be adjusted such that the airflow can reach the
required area.
▶ Press the Spot key to adjust the required swing angle:
Climate 6100i/8100i – 6721821568 (2020/11)
0010035536-001
0010031001-001
0010030497-001