Advertisement
3
Connect the other external SCSI devices by linking each device
to the previous one, as shown below. Terminate only the device
at the end of the chain.
4
Connect power cables to all external device(s) and to the
computer.
More Information About Termination
The last SCSI device on the end of each SCSI bus cable must be
terminated, and termination must be disabled for all other devices
in the middle of the cables. Ultra320/160 and Ultra2 SCSI devices
are automatically unterminated, but Ultra SCSI and Fast/Wide
SCSI devices do have termination that you must check. For more
information, refer to the documentation for each SCSI device.
If you are using external Ultra2 or Ultra320/160 devices, be sure to
use an LVD terminator to terminate the last device in the chain. If
you use a single-ended, active terminator (sometimes called an
Ultra terminator) the SCSI devices will not operate properly.
9
Advertisement
