ABSCO SHEDS RG37601N2 Manual page 22

Roof Sheeting
8 sheets per
side of roof
• On the ground, lay out the roof sheeting as if
they were on the frame already. Using a piece of
wood, as pictured, turn up the pans of each sheet
at the end that's going to be at the ridge. This will
prevent rainwater entering the structure during
windy conditions.
Hardwood with
25mm saw cut.
• Fit the roof sheets in the same manner as the wall
sheets. Each sheet should line up with the side wall
sheet.
• The roof sheets should overhang the side wall
sheet by 30mm to allow water to run into the
gutters when installed.
Absco Industries Assembly Instruction Manual
ABSCO GARAGE
MODEL: RG37601N2
3.7m W x 6.0m D x 3.2m H
190
Slot roof sheet into
cut in wood and
bend
• Avoid walking on the roof so sheeting is not
damaged. If it is necessary, walk only on the pans
at purlin locations after sheets have been secured.
• Use one Hex head tek screw with neoprene washer
(FAST035) at every second pan to ridge and outer
purlins.
• Use one Hex head tek screw with neoprene washer
at every second pan to the middle purlins.
• Lay the ridge capping (TR30) centrally on the roof,
overlapping the sections to make the same length
as the roof sheeting. Fix the capping to every
second rib of the roof sheets beneath it.
Model: RG37601N2 31/08/20 22