ABSCO SHEDS RG37601N2 Manual page 2

Before Getting Started:
• Read these instructions carefully and fully so that an understanding of the steps involved in
construction is obtained. Do this with constant reference to the engineering drawings provided.
• Measure and check off all the components prior to commencement. If a discrepancy is
discovered, contact Absco immediately for assistance.
Part Numbers:
• All framing sections & wall and roof sheets have part numbers printed on them. The remainder
of the components should be identified by their description, size and pictures provided in the
component lists.
Roller Door Instructions and Engineering Certification:
• Absco Industries supplies roller doors from another Australian manufacturer. The instructions to
install the door are supplied with the roller door and are not covered in this document.
• The engineering documentation that certifies the door to the appropriate wind loading is also
supplied by the manufacturer.
Anchor Sets Not Supplied:
• Sleeve anchors are detailed but not supplied with this garage. They can be purchased readily
from most hardware stores. Anchors required for this garage is 20x M12x60mm Sleeve Anchor.
Self Drilling Tek Screws:
• Hex head tek screws (FAST035) are to be used unless noted otherwise.
• Hex head tek screws with neoprene washer (FAST033) are to be used for securing roof sheets to
framework.
• Wafer head tek screws (FAST014) are to be used on the outside of framework to keep these
surfaces as smooth as possible so that sheeting can be secured to them.
• All roof and wall sheets are pan fixed. ie: Screwed through the flat pan of the steel sheeting into
the framework.
Personal Access Door (P.A. Door):
• If you have selected the optional Personal Access Door, P.A. Door, There is an additional
instruction manual that is to be used in conjunction with this document.
Absco Industries Assembly Instruction Manual
ABSCO GARAGE
MODEL: RG37601N2
3.7m W x 6.0m D x 3.2m H
Model: RG37601N2 31/08/20 2