Frame Construction
4. Remaining Internal Frame and Front Frame.
•
Secure the remaining internal frame in the same
manner as before. Checking everything is straight
and square as you go.
•
Connecting the side wall girts
to front frame requires the
tabs be bent at a right angle
just like we did before with
the rear frame.
5. Fit Strapping
•
Using a tape measure the roof diagonal dimension
to make sure that the frame is exactly square.
•
Fit the strapping (FAST040) diagonally over the
top of the frames from corner-to-corner, pulling
tightly and securing with three screws at every
point that the strapping crosses the internal
frames.
•
Repeat this procedure for
the rear frame
Absco Industries
Assembly Instruction Manual
ABSCO GARAGE
MODEL: RG37601N2
3.7m W x 6.0m D x 3.2m H
Model: RG37601N2
31/08/20
17