Canon NP6218 Service Handbook page 70

CHAPTER 4 SERVICE MODE
No.
311 Left/right margin adjustment
(Direct; home position for slide
shutter for blank exposure)
312 Left/right margin adjustment
(Reduce; travel distance of slide
shutter for blank exposure)
313 Primary output voltage correction
(corrects output voltage
determined by APVC)
314 APVC measured current shift
(corrects the results of APVC)
315 Voltage correction for
measurement in APVC (corrects
voltage for measurement applied
at time of APVC)
316 Measurement current correction
for APVC (corrects current
measured at time of APVC)
317 Fluorescent lamp pre-heating
current adjustment
318 Transfer output voltage
adjustment (corrects transfer
voltage determined by ATVC)
319 Arch adjustment when
multifeeder is used (pick-up roller
OFF timing)
4-10
Description Settings
0 ~ 15 A higher setting increases the
margin on both left and right.
default: 8
unit:
A higher setting increases the
-10 ~ +10
margin on both left and right.
default: 0
unit:
-16 ~ +16 Enter the setting recorded on the label
after replacing the drum cartridge.
Enter the setting recorded on the label
-40 ~ +40
after replacing the drum cartridge.
-16 ~ +16 default: 0
unit:
Enter the value recorded on the label
on the composite power supply when
replacing the composite power supply.
-10 ~ +10 default: 0
Enter the value recorded on the
label on the composite power
supply when replacing the
composite power supply.
-9 ~ +9 default: 0
Enter the value recorded on the
label on the composite power
supply when replacing the
composite power supply.
Convert the value recorded on the
-4 ~ +4
label on the composite power
supply as follows and change the
value recorded on the service label;
then, enter the value when replacing
the composite power supply.
Label
1
2
3
4
5
0 ~ 63 A higher setting increases the arch.
default: 25
unit:
Remarks
0.27 mm
0.27 mm
16 V
Input Label Input
0 6
-1 7
-2 8
-3 9
-4
0.27 mm
+1
+2
+3
+4