Table of Contents
Advertisement
CHAPTER 2 STANDARDS AND ADJUSTMENTS
7) Fix the harness in place using two SK binders (WT2-5145; front, rear)
it into the transfer guide.
Caution:
When fixing the harness in place, make sure that the cap portions of the terminals
alternate; keeping them in parallel will bring them in contact with the transfer roller.
8) Fix the harness with two SK binder
transfer guide.
9) Connect the connector
Caution:
When attaching the transfer guide to the copier after attaching the drum heater,
make sure that the spring at the rear is firmly in the groove.
2-20
(front, rear) in place, and insert it into the
Figure 2-29
as shown in Figure 2-30.
Figure 2-30
; then, insert
Advertisement
Table of Contents
