Cisco ASR 1000 Series Quick Start Manual page 27

LED Label LED
MAJ Major
MIN Minor
LINK 10/100/1000 RJ-45
BOOT eUSB FLASH
BOOT (BootDisk)
CARRIER BITS
**Built-in 4 LEDs total, one for each
6xGE SPA SFP SFP
Port Status
CC - PWR Embedded SIP power rail
status
CC - STAT Embedded SIP current status Green
**For more information about the small form-factor pluggable (SFP) transceiver modules that are compatible with Cisco ASR 1002-X Built-in
Gigabit Ethernet Ports (6x1GE), refer to the Modular Optics Compatibility section in the
SIP and SPA Hardware Installation Guide.
Table 4 provides information about the Cisco ASR1000-ESP5 LEDs in the Cisco ASR 1002-X Router as the system starts.
Table 4 Cisco ASR1000-ESP5 and ASR1000-ESP10 LED Activity
LED Label LED
PWR Power
STAT Status
ACTV Active
STBY Standby
During the boot process, observe the system LEDs. The STATUS LED comes on immediately as amber, then turns to green when
the Cisco IOS is booted.
Note The system boots differently depending on the configuration that ships with your system. The display below is a
snapshot of messages that are output on the console of the Cisco ASR 1002-X Router system after power-up and during
IOS booting. This is only an example of what you might see from any Cisco ASR 1000 Series Router.
Color In the Power Up State -Behavior Description
Solid red Major alarm indicator.
Amber Minor alarm indicator.
Flashing green Link activity indicator.
Off No link.
Solid green Link with no activity.
Flashing green Activity indicator.
Off No activity.
Green In frame and working properly.
Off Out of service or not configured.
Amber Fault or loop condition.
Off Port is not enabled.
Amber Port enabled. Problem with the Ethernet link.
Green Port enabled and the Ethernet link is valid.
Green If all power supplies within their tolerance specifications.
Green only when the SPA drivers have started and are
running and all critical processes are running.
Yellow ROMMON is running and during the download and
boot.
Red A fault is detected or the card is powering up.
Color Behavior Description
Solid green All power supplies are within operational limits.
Off The router is in standby mode.
Green Code has successfully downloaded and is operational.
Yellow BOOT ROM has successfully loaded.
Red Not booted.
Green The embedded services processor is green when active.
None Will always be off.
Cisco ASR 1000 Series Aggregation Services Routers
27