Cisco ASR 1000 Series Quick Start Manual page 15

Connecting AC Power to the Cisco ASR 1002-X Router
Step 1 Insert an AC power supply in power supply Slot 0 or power supply Slot 1 until it is full seated.
Tighten the captive installation screws.
Step 2
At the rear of the router, check that the power switch is in the Off (O) position.
Step 3
Insert the AC power cord into the power inlet and then turn it On (I).
Step 4
Step 5 To ensure that the AC power cord does not interfere with other cables or wires, dress the AC power cable in one of the
following ways.
a. Leave a small service loop in the AC power cord from the inlet and then secure the power cord through the AC power
supply handle as shown in
Figure 11 Cisco ASR 1002-X Router AC Power Cord
1 AC power cord and service loop
b. Take the power cord and run it below the handles of the power supply in slot 1 (the power supply you are connecting)
and the power supply in slot 0 (left) as shown in
be disconnected from the AC power inlet.
Figure 12 Cisco ASR 1002-X Router AC Power Cord - Left and Right
Do not run the AC power cord through the power supply handles as shown in
Caution
Figure 11. Or go to 5b.
OU TP UT
IN PU T
FA IL
OK
Th is un it
m igh t ha ve
on e po we
r su pp ly co
Al l co nn ec
tio ns mu st
to de -e ne
rg ize th e
1
Figure
OU TP UT
INP UT
FAN
FAI L
OK
OK
Thi s uni t
mig ht hav
e mo re tha
one pow er
sup ply con n
All con nec nec tion .
tion s mu st
to de- ene be rem ove
rgiz e the d
uni t.
FA N
OK
m or e th an
nn ec tio n.
be re m ov
ed
un it.
12. Make sure the power cord is hanging loosely so that it cannot
OU TP UT
INP UT
FAN
FAI L
OK
OK
Thi s uni t
mig ht hav
one pow er e mo re tha
n
sup ply con
All con nec nec tion .
tion s mu st
be rem ove
to de- ene
rgiz e the d
uni t.
Figure 13.
15