Precor SPINNER CHRONO POWER Service Manual page 131

crank arm using a 15 mm wrench then use an 8 mm hex key to press the pedal out of
the crank arm.
4. Repeat steps to remove the left pedal.
Installation instructions:
5. Insert the right pedal into the right crank arm. Seat the pedal by using a rubber mallet
to lightly tap the center of the pedal into the crank arm.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
5 Replacement Procedures
Pedal Replacement
Page 123