Pandora Smart Moto Manual page 25

Level №4 – Reset to the factory settings
The procedure recovers the factory settings of the system without deleting previously registered
devices (tags, mobile device, relays, etc.) that is stored in the non-volatile memory.
Enter the programming level №4:
• Press and hold the VALET button for more than 4 seconds. Release the button after a sound of the
Siren. The system will confirm the resetting to the factory settings with a long red flash of the LED
indicator. After that, the system will reset the settings to default and return to the programming
level №0.
Level №10 – Manage Bluetooth devices / Firmware Update
!
a
ll addiTiONal dEvicEs iNcludEd iN ThE sysTEm sET arE pairEd wiTh ThE sysTEm
b 14.
luETOOTh dEvicEs musT NOT ExcEEd
a
ll fuNcTiONs Of This lEvEl arE availablE iN ThE
f
Or ThE maNagEmENT Of ThE addiTiONal dEvicEs gO TO
f
Or ThE firmwarE updaTE Of ThE addiTiONal dEvicEs gO TO
f
Or a dETailEd dEscripTiON Of pairiNg prOcEdurE fOr spEcific dEvicE chEck iT
This level is used to pair/remove/update additional devices of the system. Each device is paired at
a sublevel. To pair devices of the same type, a sublevel is divided into cells. To enter a sublevel or a
cell of sublevel make a pause for more than 1 second, then press (P) the VALET button the number of
times equals to the desired sublevel or cell number: «Level №10» (1sec) «Sublevel 1...10» (1sec) «Cell
of sublevel 1...4».
PAIRING/DELETING AN ADDITIONAL DEVICE
Each sublevel or cell displays it's current state by a color of the LED: green light means the system is
ready for pairing, red light means a device has been already paired and it is required to delete it for
pairing a new device. To delete a device, press and hold the VALET button for 3 seconds (4 orange
flashes of the LED, or 3 sound signals of the Siren). The system will be in pairing mode for 1 minute.
After a minute or immediately after pairing a device, the system will automatically enter the
programming level №0.
PAIRING RADIO TAGS BT760/BT770/BT780
• Enter the programing level №10.1.1...3.
• If the LED is green, the system is ready for pairing.
48
PA N D O R A S M A R T M OTO / S M A R T M OTO P LU S
. T
hE maximum NumbEr Of pairEd
p s b
aNdOra pEcialisT app whEN usiNg a luETOOTh cONNEcTiON
«a » -> «p /
dvaNcEd mOuNTiNg airiNg uNpairiNg dEvicEs
«a » -> «s
dvaNcEd mOuNTiNg ysTEm dEvicEs
' .
s maNual ON www paNdOraiNfO
• Press and hold button on a tag until the 6 flashes of the tag status indicator, release the button;
• The system will confirm pairing with a sound signal from the Siren and the LED will light red.
• The system will enter the programming level №0.
PAIRING PANDORA BAND
• Enter the programing level №10.2.1...3.
• If the LED is green, the system is ready for pairing.
• Press and hold button on the Band for 6 seconds;
• The system will confirm pairing with a sound signal from the Siren and the LED will light red.
• The system will enter the programming level №0.
PAIRING DOOR SENSOR DMS-100 BT
• Enter the programing level №10.3.1...4.
. • If the LED is green, the system is ready for pairing.
». • Open the plastic case of the sensor carefully and insert a battery inside.
». • The system will confirm pairing with a sound signal from the Siren and the LED will light red.
. . • The system will enter the programming level №0.
cOm
PAIRING A SIREN PS-332 BT
• Enter the programming level «Pairing an additional device RHM-03BT/PS-331BT/PS-332BT» (level
№10.6);
• System is ready for pairing, the LED lights green;
• Put a magnet on the selected zone and connect the power supply, the siren will be paired with the
system;
• The system will confirm pairing with a sound signal from the Siren and the LED will light red.
• The system will enter the programming level №0.
UPDATING FIRMWARE OF AN ADDITIONAL DEVICE
• To update firmware of an additional device, enter the «Level №10» «Sublevel» or «Cell» corresponding
to an additional device. The LED will light red after entering. Press and hold the VALET button for 5
seconds until 6 orange flashes of LED indicator or 5 sound signals of the Siren. Open the Pandora
Specialist or Pandora BT app, go to «Search device» screen and select the device and then select one
of the update options:
• INTERNET – It allows you to upload firmware from a server.
• FILE MANAGER – This function is available only for Android devices. It allows you to upload firmware
from the phone storage.
U S E R A N D I N S TA L L AT I O N M A N UA L
49