Last 10 System Events; Run/Fault History - Bryant Evolution Connex Control SYSTXBBECC01-C Installation Instructions Manual

6.5.8. Last 10 System Events

This screen will show the last 10 events that occurred throughout the
system. Each entry has the time and date incident recorded. These events
are stored in the memory of the control and are resettable in the
THERMOSTAT SETUP screen under the RESET FACTORY
DEFAULT selection. Each entry shows the equipment that generated the
event. To return to the previous screen, touch BACK. To exit the Service
menus, touch DONE.

6.5.9. Run/Fault History

This information is stored in the equipment circuit boards (if
communicating) and displayed on the control. The indoor unit and
outdoor unit (if communicating) have the following histories. To return to
the previous screen, touch BACK. To exit the Service menus, touch
DONE.
• Resettable Faults: Fault counters for each piece of equipment that can
be reset.
• Cycle Counters: Number of heat/cool/power cycles the unit has
performed.
• Run Times: Lifetime hours of operation in heating, cooling, and how
long the unit has been powered.
67
A12151