PACKING AND STORING
All machines are packed in cardboard boxes specific for each unit .
The indications required to correctly handle the appliance while storing and
installing it are written on the packing .
The storage temperature must be between -25°C and 55°C .
Note: Do not throw the packing away exteriors to avoid environmental pollution .
Once the place in which the unit is to be installed has been chosen (see the
relative sections) proceed as follows to unpack the two units:
Indoor unit (fig . 1):
1 . Cut the two nylon straps .
2 . Open the upper side of the packing .
3 . Take the unit and lift it up until completely out of the packing .
4 . Remove the side protections and the nylon wrapping .
CONTENT
Packagings contain the units as well as accessories and technical documentation for the use and installation . Check
that the following components are present .
In the indoor unit:
Description
Remote control
Unit fastening plate
Press-in plugs for unit fastening
and remote control holder
Screws
Manuals
INSTALLATION NOTES
1 .The air conditioner is not allowed to use in a room that has running fire (such as firesource, working coal gas ware,
operating heater) .
2 .It is not allowed to drill hole or burn the connection pipe .
3 .The air conditioner must be installed in a room that is larger than the minimum room area . The minimum room area
is shown on the nameplate or following table 1 .
4 .Leak test is a must after installation .
Refrigerant charge (kg)
Min room area m²
8
INSTALLATION
Image
≤1.2
1 .3
1 .4
/
1 .6
1 .9
Qty
5-8
5-8
1+1
1 .5
1 .6
1 .7
2 .1
2 .4
2 .8
Notes
The remote control is not
1
supplied with batteries
Fix on the rear part of
1
the unit
According to the model
According to the model
User manual and
installation manual
1 .8
1 .9
2 .0
3 .1
3 .4
3 .8
Fig . 1