The diagnostic problems does not identify which adapter or device failed, which installed devices are incorrect,
whether a short circuit is suspected, or whether the system is inoperative.
Follow these procedures to isolate the failing FRU (do not isolate non-defective FRU).
NOTE: Verify that all attached devices are supported by the computer.
NOTE: Verify that the power supply being used at the time of the failure is operating correctly. (See "Power
System Check" on page 80):
Power-off the computer.
Visually check them for damage. If any problems are found, replace the FRU.
Remove or disconnect all of the following devices:
Printer, mouse, and other external devices
Hard disk drive
CD-ROM/Diskette drive Module
Power-on the computer.
Determine if the problem has changed.
If the problem does not recur, reconnect the removed devices one at a time until you find the failing FRU.
If the problem remains, replace the following FRU one at a time. Do not replace a non-defective FRU: