Network Settings - Digital Watchdog MEGApix CaaS DWC-MB44LPRC2 User Manual

Setup - Network Setup

Network Settings

10
1
Network Type
Define network IP address type from the Static Mode for the
fixed IP or the Dynamic Mode by the dynamic IP address.
If you select the Static Mode, you must fill out IP Address,
Subnet Mask, Gateway, DNS Server and all ports.
If you select the Dynamic Mode, the IP address will be
allocated automatically by DHCP equipment. If you click
the Apply button to update changes, the system will be
re-booted. In this case, you have to reconnect the camera
using new IP address.
2
IP Address
Define the IP address. The address is consisted of four
numbers separated by dots and the range of each number
is from 0 to 255.
3
Subnet Mask
Define the Subnet Mask. Format is same as the IP address.
4
Default Gateway
Default the Gateway IP Address. Format is same as the IP
address.
5
Preferred DNS Server
Define the DNS server IP address. Format is same as the
IP address.
6
Alternate DNS Server
Define the Secondary DNS server IP address. Format is
same as the IP address.
7
HTTP Port
The HTTP port can be set to 80 which default or in between
1025 to 60000.
8
HTTPS Port
The HTTPS port can be set to 443 which default or in betwe
-en1025 to 60000.
9
RTSP Port
The RTSP port can be set to 554 which default or in between
1025 to 60000.
10
Click 'Apply' to make above setting effective.
If the network type is dynamic, the IP address is changed in
below cases. Therefore, the IP address needs to be searched
again, and the camera needs to be reconnected in these
cases.
- When the camera power is on / off.
- After Firmware update, Default set and reboot.
1
2
3
4
5
6
7
8
9