Table of Contents
Advertisement
Water system
The water level in the evaporator is controlled by a feed solenoid and level detecting sensors. Referencing the
diagram below, water sensing rods extend down into the reservoir at the end of the evaporator assembly. The system
works via electrical conductivity as follows:
One of the longest probes is a common. When water is between any of the other probes and the common, the PC
board will sense the activation. During normal operation, the water level rises and falls between the Normal High and
Normal Low sensors. As water is consumed to make ice, the level will fall until the Normal Low sensor is exposed,
triggering the water feed solenoid on. Water will fill until the Normal High sensor is activated.
Note: The potable water dissolved solids content must be greater than 10 ppm for the water control system to
function properly. If using reverse osmosis water filtration system, ensure T.D.S level is greater than 10 ppm.
Water system diagram
Water level diagram
Horizon HCD700R/N, HMD700R/N Ice Machines
NORMAL
OPERATING
RANGE
13
Advertisement
Table of Contents
