Installation; Planning Layout And Preparation - Power works Optimow 10 Operator's Manual

Installation

EN
Read the entire section before beginning installation. Installation affects mower capability.
Plan the installation carefully.
The following are the main tasks within the installation:
•

Planning layout and preparation

•
Installing and connecting the charging station
•
Connecting the power supply
•
Initial charging of the battery
•
Installing the boundary wire
•
Installing the guide wire
•
Calibrating and initial start up
Planning Layout and Preparation
Ensure that the following conditions exist in the operating area where the mower will be used:
•
The grass is shorter than 10 cm.
•
There are no stones, loose pieces of wood, wire, live mains cables, and other foreign objects.
•
The operating area is even and has no ditches, grooves, and steep slopes greater than 35%.
The following tools are required for installation, but not included:
•
Hammer/rubber mallet to drive the pegs into the ground
•
Combination pliers to cut the boundary wire
•
Polygrip to press the couplers together
•
Hex key, 6 mm for securing the charging station to ground
8
POWERWORKSTOOLS.COM