Welbilt Frymaster FilterQuick FQG30U-easyTouch Installation, Operation And Maintenance Manual page 29

3. Then in reverse order, place the metal filter screen in
the center of the bottom of the pan, then lay a sheet of
filter paper on top of the screen, overlapping on all
sides (see Figure 11).
4. Position the hold-down ring over the filter paper and
lower the ring into the pan, allowing the paper to rest
on the sides of the filter pan (see Figure 11).
5. Replace the crumb tray in the filter pan, then push the filter pan
back into the fryer, positioning it under the drain.
6. Push the filter pan back into the fryer, positioning it under the fryer.
Ensure "P" is NOT displayed on the controller. The filtration system
is now ready for use.
Do not drain more than one frypot at a time into the built-in filtration unit to avoid
overflow and spillage of hot oil that may cause severe burns, slipping and falling.
The crumb tray in fryers equipped with a filter system must be emptied into a fire-
proof container at the end of frying operations each day. Some food particles can
spontaneously combust if left soaking in certain shortening material.
Do not bang fry baskets or other utensils on the fryer's joiner strip. The strip is
present to seal the joint between the fry vessels. Banging fry baskets on the strip
to dislodge shortening will distort the strip, adversely affecting its fit. It is de-
signed for a tight fit and should only be removed for cleaning.
Inspect the filter con-
nection fitting
O-rings.
DANGER
DANGER
WARNING
3-8
Figure 10
Figure 11