Welbilt Frymaster FilterQuick FQG30U-easyTouch Installation, Operation And Maintenance Manual page 27

3.3.3 Changing the JIB (Jug In
Box) oil reservoir
When the oil reservoir level is low and
displays TOP OFF OIL EMPTY – REPLACE
JIB, (see Figure 3). Once the reservoir is
refilled and/or replaced, press and hold
the orange reset button next to the oil
reservoir (see Figure 8 on the following
page). Press the check button to tempo-
rarily clear the screen. The message in the
lower corner continues to be displayed
until the orange reset button is pressed.
If using solid shortening, see Appendix B
for instructions.
.
1 Open the cabinet and slide the JIB
from the cabinet (see Figure 4).
Figure 4
3. Place new JIB upright and remove the
cap and foil seal (see Figure 6).
Figure 6
Do not add HOT or USED oil to a
JIB.
2. Remove the cap and pour
4. Put the tube in the new full
5. Slide the JIB onto the shelf
6. Press the JIB reset switch to
WARNING
Top Off Oil Empty indicates that the oil reservoir is
empty.
any remaining oil in the con-
tainer into all fry vats equal-
ly (see Figure 5).
container (see Figure 7).
inside the fryer cabinet (as
seen in Figure 4).
clear the Top Off Oil Empty
display on the FQ4000 control-
ler (see Figure 8).
3-6
Figure 3
Figure 5
Figure 7
Figure 8