Removing The Memory Card; Powering The Camera - Rexing V1P Gen3 User Manual

Inserting a memory card
1. If the device is powered on, press and hold the Power
button to power down.
2. Insert the card in the orientation shown.
3. Push the card into the slot, listening for a click sound
signaling the card is securely inserted.
Step 2.2: Removing the Memory Card
Before removing a memory card from your V1P Gen3, you must
first dismount it for safe removal.
With the device powered down, press down on the memory
card until you hear a click. Gently remove your finger (or other
pressing object) to allow the spring release to push the memory
card out of the slot.
Do not remove the memory card while the device is
transferring or accessing information. Doing so can result
in data loss or corruption or damage to the memory card or
device. Rexing is not responsible for losses that result from the
14
Press the Power
button to turn the
power off
use of damaged memory cards, including the loss of data.
Step 3.1: Powering the Camera
You must always connect the V1P Gen3 to a power source
while operating the camera. Connect the camera to your
vehicle via the included car charger cable. Connect the larger
end of the car charger cable to your car's cigarette lighter (12V
DC power outlet). Connect the other mini-USB end to the mini-
USB port on the device.
Connecting the charger improperly may cause serious
damage to the device. Any damage caused by misuse is
not covered by the warranty. Use only Rexing-approved
chargers. Using unapproved chargers or cables can damage
the device.
If the device receives an unstable power supply, the screen
15