Page 2
Failure to comply with safety warnings and regulations can result in serious injury or death. Rexing Dash Cam is not intended to be touched, modified, or calibrated while operating a vehicle. Rexing is not responsible for any damages resulting from the user's misuse of the camera.
Page 3
• Rexing cannot be responsible for the user’s safety when using accessories or supplies that are not approved by Rexing. Do not drop the charger or device, or subject them to impact. Handle and dispose of the charger and device with care.
Page 5
If you notice strange smells or sounds coming from your device, or if you see smoke or liquid leaking from the device, stop using the device immediately and take it to a Rexing Service Center. Failure to do so may result in fire or explosion.
Page 9
ANY CONTENT OR SERVICE MADE AVAILABLE THROUGH THIS DEVICE AND UNDER NO CIRCUMSTANCES, INCLUDING NEGLIGENCE, SHALL REXING BE LIABLE, WHETHER IN CONTRACT OR TORT, FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL OR CONSEQUENTIAL DAMAGES, ATTORNEY FEES, EXPENSES, OR ANY OTHER DAMAGES...
Page 10
Third party services may be terminated or interrupted at any time, and Rexing makes no representation or warranty that any content or service will remain available for any period of time. Content and services are transmitted by third parties by means of networks and transmission facilities over which Rexing has no control.
Page 11
Content may differ from the final product or from software provided by service providers, and is subject to change without prior notice. • For the latest version of this manual, refer to the Rexing website at www.rexingusa.com. • Available features and additional services may vary by device and software.
Getting Started Overview of your V1LG Dashboard Camera GETTING STARTED Up Navigation Button Down Navigation Button Emergency lock button MircoSD Card Slot Device Layout Rear camera port Mini USB port Reset Button . Menu Button 12V Charging port 2. Mode Button Lens Angle Adjuster 3.
Getting Started Unpacking your V1LG Dashboard Camera Buttons Button Functions • Press to turn on and off screen • Hold to turn the device on or off • Press to confirm a selection while in Setting Mode • Click to start or stop recording •...
Getting Started Unpacking your V1LG Dashboard Camera Status Icons Icon Meaning Video Resolution Blinking – Recording Wide Dynamic Range Charging Battery Power Level Microphone Mute Microphone On Video Recording Mode Video Playback Mode Photo Mode Memory Card Inserted GPS Signal...
Page 21
Using an incompatible charger can cause serious personal injury or damage to your device. Rexing V1LG can ONLY powered by 12V Charging port. You can NOT charge unit via USB port. 5. Format the memory card...
LED is ON. • Battery is mainly used to save files in emergency. Please always connect Rexing V1LG to external power while it is in use. • When device detects no power supply, it will automatically power off after 5 seconds.
Any damage caused by misuse is not covered by the warranty. Inserting the memory card The V1LG accepts Micro SD memory cards (class 10 or higher) with a maximum capacity of 256GB. Depending on the memory card manufacturer and type, some cards may not be compatible with your device.
Do not remove the memory card while the device is Powered ON. Doing so can result in data loss or corruption, or damage to the memory card or device. Rexing is not responsible for losses that result from the use of damaged memory cards, including the loss of data.
Getting Started Quick Start Basic Operation • Rexing Dash cam will atomically start recording once power on, the indicator and the red dot icon on screen should flashing while recording. • During recording, press EMERGICY button to lock current video clip, so the loop recording will not overwrite locked video clip. All locked video clip files can be found under \CARDV\MOVIE\RO folder in memory card.
Operating your V1LG Dashboard Camera Video Settings VIDEO SETTINGS On Video Recording Mode, Press OK to stop recording then press MENU button once open Video Settings Menu. Resolution Recommend setting: 1080FHD Use this menu to set the recording resolution. Rear-View Camera...
Operating your V1LG Dashboard Camera Video Settings Recommend setting: +0.0 Adjust the camera exposure value for brighter or darker recorded video, per your preference. Recording Audio You may choose to record audio with video, or turn off the microphone so that all recorded videos will be muted.
Operating your V1LG Dashboard Camera Video Settings Time-lapse Record Recommend setting: Off Time-lapse photography is a technique whereby the frequency at which film frames are captured (the frame rate) is much lower than that used to view the sequence. When played at normal speed, time appears to be moving faster and thus lapsing.
Operating your V1LG Dashboard Camera System Settings SYSTEM SETTINGS On Video Recording Mode, Press OK to stop recording then press MENU button twice open System Settings Menu. Date/ Time Setup Use this menu to change the device’s time and date.
Operating your V1LG Dashboard Camera System Settings Frequency Recommend setting: U.S. - 60Hz This option should be set according to the power supply specification used in your country or geographical region (U.S. users should select the "60Hz" option). Screen Saver Recommend setting: 15 Seconds Select a time duration for the screen to stay lit after recording starts.
Operating your V1LG Dashboard Camera System Settings Car No. Enable this feature to enter your vehicle plate number for video recording. The plate number will stamp in the video. UP/Down – Change value OK – Move to next segment MENU – Save Settings Enable/Disable Daylight Saving Time.
Operating your V1LG Dashboard Camera Photo Settings PHOTO SETTINGS On Photo Mode, press MENU button once open System Settings Menu. Capture Mode Recommend setting: Single With this feature you can set a timer for automatically capturing images. Resolution Recommend setting: 5M This option allows you to set the pixel resolution for captured images.
Operating your V1LG Dashboard Camera Photo Settings Sharpness Recommend setting: Normal This feature will automatically enhance captured images for a clearer, more distinct picture. White Balance Recommend setting: Auto This setting allows you to adjust the lighting balance for different environments.
Operating your V1LG Dashboard Camera Photo Settings Anti-Shaking Recommend setting: Off This feature enables the image stabilizer function to reduce blurring of captured images. Date Stamp Recommend setting: Date/Time This feature will automatically apply a date and/or time stamp to captured images.
Operating your V1LG Dashboard Camera Playback Function PC GPS Playback Function GPS Player Instructions "GPS Player Software" is designed to play recorded videos along with displaying GPS data and driving routes on a computer. Minimum System Requirements: Monitor Resolution: 1280*720...
Page 38
Operating your V1LG Dashboard Camera Playback Function Plugin XP.exe" file from the CD ROM to install a MOV video codec. Depend on your OS security setting, you may need to right click software icon and "Run As Administrator". The Software Main Screen A.
Operating your V1LG Dashboard Camera Playback Function Playback Mode (Video) You can play back recorded video on your device using the following steps: 1. Press OK to stop recording 2. Press MODE twice to switch from Recording to Playback Mode 3.
Operating your V1LG Dashboard Camera Playback Function Deleting Files To delete one particular file: 1. Press the UP or DOWN button to navigate through the stored video files 2. Press MENU to view options for the highlighted file: Delete/Protect/Slide Show 3.
Operating your V1LG Dashboard Camera Updating Firmware Updating Firmware The following procedure will allow you to use the Rexing website to update firmware for your V1LG Dashboard Camera. This is necessary for enabling all available features on your device. 1. Go to firmware.rexingusa.com download the firmware file to your computer 2.
Operating your V1LG Dashboard Camera Troubleshooting General Troubleshooting Problem Possible Cause Solution Memory card may be Reformat memory card or full or malfunctioning The captured image replace with a new one Image not being saved is not stored Make sure to stop recording...
Page 43
Operating your V1LG Dashboard Camera Troubleshooting Charge the battery for 3 hours. Make sure unit is off Battery may be while charging. Turn on the depleted unit, unplug it. If it turns off Not holding charge Power cord may be...
Page 44
Operating your V1LG Dashboard Camera Troubleshooting SD Card may not be Use a different SD Card compatible Restore to default settings Keeps Turning off Might not be getting Get a replacement power continuous power. cord Check remaining space on memory card and delete files...
Page 45
Operating your V1LG Dashboard Camera Troubleshooting Stops Recording SD Card may not be Restore to default settings after 1-3 looped files compatible Use a different SD Card “File error" is Memory card may be encountered when corrupted with bad Reformat the memory card.