3Com 3CP5610A User Manual page 87

Table6-3
Register
S9
S10
S11
S12
S13
S14
S15
S16
S17
Default Function
6 Sets required duration, in
tenths of a second, of
remote modem's carrier
signal before recognition by
your 3Com U.S. Robotics
modem.
14 Sets duration, in tenths of a
second, that modem waits to
hang up after loss of carrier.
This guard time allows your
modem to distinguish a line
disturbance from a true
disconnect (hang up) by the
remote modem.
Note: If you set S10 = 255,
the modem will not hang up
when carrier is lost.
Dropping DTR hangs up the
modem.
70 Sets duration and spacing, in
milliseconds, for tone dialing.
50 Sets duration, in fiftieths of a
second, of guard time for
escape code sequence (+++).
0 Bit-mapped register. Select
the bit(s) you want on and
set S13 to the total of the
values in the Value column.
For example, ATS13 = 17
enables bit 0 (value is 1) and
bit 4 (value is 16).
Refer to Table 6-4
0 Reserved
0 Bit-mapped register setup.
To set the register, see
instructions for S13. Refer to
Table 6-5.
0 Reserved
0 Reserved
S Registers 81