Subaru 2006 Legacy Owner's Manual page 185

5-12
Audio
Press the "RPT" button
Press the " " or "
SEEK/SCAN button
Press the " " button
Select the radio mode
Turn off the power of the audio
equipment.
Turn the ignition switch to the "OFF"
position.
Scan
SEEK
SCAN
The scan mode lets you listen to the first
10 seconds of each track on the disc in
succession. Press the "
SEEK/SCAN button to start scanning
through all tracks upward beginning with
the track following the currently selected
one. Press the " " side of the button to
start scanning through all tracks down-
ward beginning with the track preceding
" side of the the currently selected one. After all tracks
on the disc has been scanned, normal
playback mode is restored.
To cancel a scan, press the "
side of the button again.
NOTE
The scan mode will be cancelled if you
perform any of the following opera-
tions:
Press the "RPT" button
Press the "RDM" button
Press the "
Press the "
TUNE/TRACK button
Select the radio mode
Turn off the power of the audio
equipment.
Turn the ignition switch to the "OFF"
position.
500232
" side of the
" or " "
" button
" or " " side of the
To eject a disc from the player
When a disc is being played back or when
a disc is in the player, press the eject but-
ton " ". The disc will be ejected.
NOTE
Avoid driving the vehicle with a CD
sticking out, because vibration might
make it fall out.
If the disc is left ejected for more
than approximately 15 seconds after
the ignition switch is turned to the
"OFF" position, a disc protection func-
tion will operate, automatically reload-
ing the disc. In this case, the disc is not
played.
500237